Hyundai Equus 2015 Owner's Manual page 140

Features of your vehicle
Flashing
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
you wish to program while keeping
the indicator light in view.
3. Simultaneously press and hold
®
both the HomeLink
held transmitter buttons until the
®
HomeLink indicator
changes from a slow to a rapid
blinking light. Now you may
release both the HomeLink
hand-held transmitter buttons.
4 48
✽ ✽ NOTICE
Some devices may require you to
replace this Programming step 3
with procedures noted in the "Gate
Operator/Canadian Programming"
section. If the HomeLink
light does not change to a rapidly
blinking light after performing these
steps, contact
www.homelink.com.
OYF042251N
®
button
and hand-
light
®
and
4. Firmly press, hold for 5 seconds
and release the programmed
HomeLink
rate times to activate the door. If
the door does not activate, press
and
®
indicator
HomeLink
the indicator light.
• If the indicator light stays on con-
®
HomeLink at
stantly, programming is complete
and your device should activate
when the HomeLink
pressed and released.
• If the indicator light blinks rapidly
for 2 seconds and then turns to a
constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
5. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
®
button up to two sepa-
hold the just-trained
®
button and observe
®
button is