Setting Up Part Armed Mode And Devices Behaviour - Yale Sync IA-310 Installation Manual

Setting up part armed mode and devices behaviour

You can change the device behaviour
settings to select the required action
when the system is fully armed or
part armed.
Go to the App menu
Settings > Alarm settings > Devices
In your device list, go into the settings
for each device and select the required
device mode.
4 different settings are available for PIR Motion Detectors and Door/Window
Contacts. Devices are pre-set to Entry. When the system is armed first users will
have 30 seconds to exit the building. If the system is already armed, triggering any
sensors will cause an entry countdown to begin.
Part armed mode is usually used to protect the perimeter or a specific zone
of the house (eg. ground floor) while you are free to be inside or in another part of
the house (eg. upstairs)
Burglar
Entry
Home Omit
Home Access
(19)
8
Key
Sensor
Ignored
Instant
Siren
Triggers
Countdown