V600 Commands - Omron V680 series User Manual

V600 Commands

There are 4 types of commands for communicating with the RF Tag using the Hand-held Reader/Writer.
• Normal commands
• Button commands
• Auto commands
• Button auto commands
Normal Commands
Normal commands are sent from the host device for communications with the RF Tag, after the
antenna end of the Hand-held Reader/Writer has been moved close to the RF Tag.
1. Move the antenna end of the Hand-held Reader/Writer close to the RF Tag.
Host device
2. Commands are sent from the host device to the Hand-held Reader/Writer.
3. The Hand-held Reader/Writer communicates with the RF Tag.
4. A response is returned from the Hand-held Reader/Writer to the host device.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
If the RF Tag is not detected within the Hand-held Reader/Writer's communication area when the com-
mand is sent from the host device, an RF Tag Non-existent Error will occur.
At this time, the operation indicator will flash red.
A
Hand-held Reader/Writer
B
Command
D
Response
Section 3
Commands
RF Tag
C
Communications
with RF Tag
RFID System
User's Manual
83