MULTIQUIP Mikasa Series Operation And Parts Manual page 19

5. If the engine fails to start, DO NOT continue to rotate the
ignition key for more than 5 seconds. Return the key to the
RUN position and wait 10 seconds before starting again
Figure 17. Starter Switch (Option)
CAUTION
While the engine is running, never try to turn the ignition key to
the START position.
6. After starting the engine, continue to warm up the engine
for about 3 to 10 seconds especially in cold weather.
7. If the buzzer does not stop sounding after the engine has
started, shutdown engine immediately and check engine
oil level. The buzzer functions as a engine oil level alam
warning device.
NOTE
Recoil Start
1. Open the fuel cock (Figure 15).
2. Move the throttle lever to the START position (Figure 16).
3. Grasp the starter grip (Figure 18) and slowly pull it out. The
resistance becomes the hardest at a certain position,
corresponding to the compression point. Pull the starter
grip briskly and smoothly for starting.
MVH-406DSY PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (11/28/05) — PAGE 19
When starting a unit with an electric
strart capability, a decompressor is
not normally required. However,
when ambient temperature or battery
charger level is low, use of a
decompressor will help make the
start-up easier.
MVH-406DSY — OPERATION
Figure 18. Engine Start Handle
4. Push down decompression lever (Figure 19) and
release.
Figure 19. Decompression Lever
5. If the engine does not start, repeat steps 4 and 5.
TRAVELING
CAUTION
Make sure to follow all safety rules referenced in the safety section
of this manual before operating compactor. Keep work area
clear of debris and other objects that could cause damage to the
compactor or bodily harm.
1. Grasp the compactor's hand grip (Figure 20), and move the
engine throttle lever (Figure 20) quickly to the fast position.
2. With the throttle lever in the fast position, the engine speed
should be around 3,600 RPM, therefore engaging the cen-
trifugal clutch
Figure 20. Throttle Lever (Fast)