Advertisement
Blue Label is a series of electric projection screens in anodized aluminum housings. A timeless
design and a wide selection of projection surfaces make it the most-chosen screen for home theater and
conference rooms. In the Tensioned version it is additionally equipped with a special system of tensioners
to get an even more tense projection surface.
1. The cassette and the bottom bar of the screen are protected against damage by polyurethane foam.
Remove the foams protecting the bottom bar after mounting the screen.
2. The screen should be installed in a location away from moisture and strong sunlight.
3. A properly mounted screen must be absolutely levelled.
4. Use a soft, moistened cloth for cleaning. Do not use active cleaners. Protect the screen from ingress of
water or other liquid inside. After cleaning, the screen should be carefully wiped to remove any
residual moisture.
5. DIMENSIONAL TOLERANCE: Projection surface: ± 20mm; components ± 3mm
6. The screen / elevator cannot have connected more than one remote control at once.
7. One remote control (for ex. RC01 / RC02 / Trigger 12V / Trigger230V / IR Receiver / RS Receiver,
etc.) cannot be connected at once to more than one screen, elevator, roller-blind, etc. Such connection
can only be made by using the SG-2 group controller.
Switch
Projection screen
Mounting bracket
Screws for the bracket
Expansion dowel Ø10
M6 washer
Wrench for adjusting the end positions of the screen
Wall key switch (available for screen without a built-in radio control)
IMPORTANT!!!
INSTALLATION AND OPERATION NOTES
Screen / elevator
Switch
engine
Package contents:
w
w
w .
k
Screen / elevator
engine
a u
b
e
r .
e
-3-
Screen / elevator
Controls
engine
Qty.
1 pcs
2 pcs
8 pcs
4 pcs
4 pcs
1 pcs
1 pcs
u
Advertisement
