Connect The Luminometer To A Computer; Install Lumissoft On The Computer - Hach Eclox User Manual

c. When Write? is shown, push PAPER FEED SW.
d. Turn on the printer.
7. If not using a DPU-414 thermal printer, configure the printer:
Option
Data length
Parity setting
Parity condition
Busy control
Baud rate

3.5 Connect the luminometer to a computer

To connect the luminometer to a computer:
1. Install the LUMISsoft software on the computer (refer to
the computer on page
2. Pull out the plug that is attached to the lanyard.
3. Connect the RS232 serial interface cable to the luminometer.
4. Connect the other end of the RS232 serial interface cable to the computer.

3.6 Install LUMISsoft on the computer

Install LUMISsoft on a computer by doing the instructions on the CD cover. A
shortcut for LUMISsoft is added to the desktop during installation.
In the lab, LUMISsoft is used to automatically get LBT Measurement Luminescence
procedure results from the luminometer during the test and put the values into
LUMISsoft. LUMISsoft then does calculations according to ISO 11348.
LUMISsoft is also used to send previous results that are saved on the luminometer
to a computer as a text file. The results can then be shown in graphical and tabular
format using Microsoft Excel
on the luminometer into LUMISsoft to do calculations.
Setting
8 bits
No
Odd
XON/XOFF
9600 bps
23).
®
. The user can also manually put test results shown
Install LUMISsoft on
23