Aqua Lung BC 1 User Manual page 17

Adjusting the Waistband Length - Nut and Bolt System
Each side of the BC waistband is connected to the harness with two nut & bolt
and washers combinations (all hardware is stainless steel). There are three
positions that allow you to lengthen or shorten the waistband, with the outer
grommets being the longest setting. If necessary, the waistband can easily be
remounted onto one of three grommet attachment points by performing the
following procedure:
1. Disconnect the chest strap buckle, shoulder strap buckles, waist buckle and
cummerbund.
2. To remove the bolts which fasten each
section to the harness, hold the nut with
a 3/8" box wrench and unscrew the bolt
with a medium sized Phillips screwdriver.
3. Align the grommet holes on the waist-
band with the grommet holes on the har-
ness. Place a washer onto the bolt. Insert
the bolt through the grommet holes on the
harness and waistband. Place a washer
onto the bolt from behind the waistband,
followed by the nut. Hold the nut securely
with a 3/8" box wrench and tighten the bolt
with a medium size Phillips screwdriver.
Repeat the process for the remaining
hardware.
4. Don the BC over your exposure suit to
check the fit.
17