Sirius Satellite Radio SIR-BB3 User Manual page 6

1. Battery Installation
Your Boom Box can operate independently of AC
power by installing 8 D-Cell batteries as follows:
NOTE: The batteries are bypassed automatically
whenever the supplied AC Adapter is
plugged into the DC 12V jack on the back
panel.
COVER LATCHES
BATTERY
COMPARTMENT
COVER
1. Turn the Boom Box upside down to access
the battery compartment.
2. Push the battery cover latches forward and flip
up the battery compartment cover to the open
position.
3. Insert eight (8) D-Cell batteries observing
battery polarity as shown; then close the cover.
POSITIVE
BATTERY
COMPARTMENT
(COVER REMOVED)
NEGATIVE
2. Cabling Interconnections
You can begin to enjoy Sirius® Satellite Radio
as soon as the Shuttle and Boom Box Kit
installation are complete. Set up your Audiovox
SIR-BB3 by following the interconnect diagram.
3. Installing the Shuttle in the SIR-BB3
Install the shuttle as follows:
1. Press the EJECT button at the top of the SIR-BB3 to
BOTTOM OF
open the spring-loaded cover. Carefully line up the
BOOM BOX
shuttle rear spine grooves with the Boom Box guide
spines; lower the shuttle into the Boom Box.
SHUTTLE
REAR VIEW
SHUTTLE
COMPARTMENT
PNP COVER
NEGATIVE
SAT
CONNECTOR
POSITIVE
-6-
SHUTTLE REAR
SPINE
GROOVES
SIR-BB3 GUIDE
EJECT BUTTON
SPINES
AUDIO OX
CONNECTOR
GUIDE PIN
20-PIN
SYSTEM
CONNECTOR
128-7266A
6 of 12