Page 2
4. When installed indoors, unplug the AC Power Adapter from the wall outlet when the SB4000 is not to be used for an extended period of time. If batteries are installed, set the Power ON/OFF-VOL control to the Off position to prevent unintentional battery discharge, or remove the batteries.
Page 3
3. Installing the SR4000 Receiver in the SB4000 Boombox: Place the SR4000 Receiver in the cradle so that the guides are lined up with the SB4000 Boombox cradle. Then push the SR4000 down to engage the connectors. The SR4000 will snap into place.
Page 4
OFF the SB4000 Boombox and SR4000 Receiver c. Disconnect the power adapter from the wall outlet receptacle. d. Plan the routing of the antenna cable to the SB4000 ANT input when indoors. Make sure you avoid any obstructions that could crimp, kink or twist the cable.
Page 5
Weight (Without Batteries) ... 5.88lbs. (2670g) Periodic Inspection The SB4000 Boombox should be inspected periodically for external damage. At least once every 30 days of use, perform the following checks: 1. Inspect the 16-pin Orbiter SR4000 Receiver connector for loose, bent or broken pins, misalignment, etc. Make sure the RF Connector (Antenna) is intact and exhibits no apparent damage.
Page 6
REMEDY Sirius Satellite Radio warrants to the original retail purchaser of this product that should this product or any part thereof, under normal Turn SR4000 Receiver power on using the use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such Orbiter Power on/off button defect(s) will be repaired or replaced with new or reconditioned product (at the Company’s option) without charge for parts and repair...
Need help?
Do you have a question about the Orbiter SB4000 and is the answer not in the manual?
Questions and answers