Advanced Configuration - Banner ABR 3000 series Quick Start Manual

Focus/Aiming
The reader includes a built-in aiming system to aid in reader positioning. Access the aiming system through the Smart Teach Interface.
1. Power on the reader.
During startup, all of the LEDs blink for one second. On the connector side of the reader near the cable, the Power LED (blue) indi-
cates the reader is correctly powered.
2.
Enter Focus/Aim mode by pressing and holding the Smart Teach button until the
3. Release the button to enter Aim mode.
The aiming system turns on.
4. Place an application specific code in front of the reader at the reading distance indicated for your model, as described above, center-
ing it a few mm to the left of the aiming system indicator as shown in the following figure.
5. Exit Aim mode by pressing the Smart Teach button once. The aiming system turns off.
Setup
Once entered, the imager automatically performs the Image Acquisition parameter calibration for the specific code presented to it.
1.
Enter Setup mode by pressing and holding the Smart Teach button until the
2. Release the button to enter Setup mode.
The Setup LED blinks until the procedure is completed. The Setup procedure ends when the Image Acquisition parameters are
successfully saved in the reader memory, the
3. If the calibration cannot be reached after a timeout of about 5 (five) seconds, ABR exits without saving the parameters to memory, the
Setup LED stops blinking, and the ABR beeps once.
Learn
Once entered, the imager starts a procedure to automatically detect and recognize a single code
will substitute the current code. To configure multiple codes, use the Barcode Manager Auto-learn procedure.
Exit Learn mode at any time by pressing the Smart Teach button once. After a short delay the Learn procedure is cancelled.
1.
Enter Learn mode by pressing and holding the Smart Teach button until the
2. Release the button to enter Learn mode.
The Learn LED blinks until the procedure is complete. The Learn procedure ends when the Image Processing and Decoding pa-
rameters for a single code are successfully saved in the reader memory, the Green Spot is activated, the
ing, the ABR beeps once, and exits Learn mode.

Advanced Configuration

Use the following procedures for a more advanced configuration of the ABR. Advanced configuration requires Barcode Manager software. For
complete configuration instructions, refer to the Instruction Manual at
tion Manual.
6
The Learn procedure does not recognize the following symbologies: Postal Codes, Pharmacode, MSI, Standard 2 of 5, or Matrix 2 of 5.
4
Figure 4. Smart Teach Interface: Aim Mode
Figure 5. Aiming Mode Using the Red Crosshairs
Figure 6. Smart Teach Interface: Setup Mode
Setup LED stops blinking, the ABR beeps once, and exits Setup mode.
Figure 7. Smart Teach Interface: Learn Mode
www.bannerengineering.com
www.bannerengineering.com - Tel: +1-763-544-3164
Focus/Aim LED is on.
FOV
Setup LED is on.
6
which is presented to it. Successive Learns
Learn LED is on.
. Search for p/n 207637 to view the Instruc-
ABR 3000
Learn LED stops blink-
P/N 207636 Rev. A