Hayward ColorLogic 4.0 Installation Manual page 25

FAQs
Can light show settings be changed while a show is running?
Yes. The settings for a show can be changed while a show is running. If you pause
a few seconds between key presses, you will be able to see the effect of the
changes while the show is running.
How do lights go from stand alone mode to program control mode?
Lights are originally shipped in stand alone mode. This mode allows the light shows
to be controlled using power line interrupts (toggling power to the light) and is similar
to the previous generation lights. The lights automatically go into program control
mode when they are configured with a Pro Logic pool controller and AQL-COLOR-
MODHV.
How do lights go from program control mode to stand alone mode?
Lights which have been installed and configured with a pool controller can be
returned to stand alone mode by using the "Reset ColorLogic" option in the Pro
Logic configuration menu. You also will need to remove the network module and
move the lights input and output power to another relay.
Can I mix ColorLogic 4.0 lights with ColorLogic 2.5 lights in stand alone
mode?
No. The timing of light shows in version 4.0 lights is not the same as version 2.5
lights. The lights will not perform at the same speed or intensity.
Page 23