MGE UPS Systems 66244 User Manual page 9

www.mgeups.com
3.2.1.1 UPS zone: general information on the UPS.
Picture and generic name of the UPS range
NB: When using a UPS with dry-contact (i.e. "dumb") communication, no picture or name is
displayed, just the "2 contacts" text is displayed and only the following parameters are specified in
the UPS status zone:
"Communication"
"Power source"
"Output"
Customise the name of your system: "upsIdentName" object of the UPS MIB (RFC 1628)
You can change this name on the "System" page.
The "About your UPS" zone provides information on the UPS and the SNMP/Web card, in
particular, the model name and software version.
3.2.1.2 "UPS status" zone: essential information
The various icons showing the status of the UPS are:
Utility power present
Battery operation
Loss of communication with the UPS
Battery fault
"Communication": indicates the status of the communication between the card and the UPS
"Power source": indicates whether the power comes from the utility or from the UPS battery
"Batteries": indicates whether the battery is being charged or discharged
"Output level": indicates the power percentage used at UPS output
"Output": indicates if the UPS output is protected
3.2.1.3 "Battery status" zone:
"Bargraph": Graphical display of the remaining battery charge (in percent).
"Battery level": Remaining battery charge (in percent).
"Remaining backup time": Estimation of the time remaining before UPS shutdown.
T H E U N I N T E R R U P T I B L E
Network Management Cards – User Manual
P O W E R P R O V I D E R
34003676EN/AA Page 9/42