Table of Contents
Advertisement
www.mgeups.com
To change the IP address of the card, press "1" then "Enter". Specify an IP address, then press
"Enter'.
2. Gateway Address
Enter the name of the gateway to be used to communicate with other sub-networks.
3. Network Mask
Enter the mask of the sub-network defining the user group to which the card is connected.
4. sysContact
Enter the name of the person responsible for the UPS.
5. sysName
Enter a string of characters to identify the UPS.
32 characters maximum
6. sysLocation
Enter a string of characters to identify the installation location of the UPS.
32 characters maximum
7. Community Read-Only
Enter the name of the read-only community (by default = public)
31 characters maximum
8. Community Read/Write
Enter the name of the read/write community. This name is used by the UM-Clients to subscribe to the
table of notified Clients. It is recommended to personalise this name.
Value by default "public".
31 characters maximum
9. HTTP Login Login
Text field limited to 10 characters. Enables secure access to the sections of the Configuration menu.
Default value "MGEUPS".
a. Manager Password
Text field limited to 10
characters.
Default value "MGEUPS".
b. BOOTP/DHCP Enabled
Authorises the configuration of network parameters with your BootP/DHCP as a startup mode (choose
enable).
Card operating mode with the server: after all reboots, the card (should this option be enabled),
attempts to recover the network parameters from the server for 10 seconds. If no response is obtained
from the server, the card boots with the last parameters saved from the previous start.
0. Return to previous menu
Goes back to the previous menu.
T H E
U N I N T E R R U P T I B L E
Network Management Cards – User Manual
: 172.17.1.1
: 255.255.0.0
: Computer Room Manager
: MGEUPS
: Computer Room
: public
: public
: MGEUPS
: *
Enables secure access to the sections of the Configuration menu.
: Enabled
P O W E R
P R O V I D E R
34003676EN/AA
Page 34/42
Advertisement
Table of Contents
