Power; Serial - Simrad R5000 Installation Manual

10

Power

The unit is designed to be powered by 24 V DC.
It is protected against reverse polarity, under voltage and over voltage (for a limited
duration).
A fuse or circuit breaker should be fitted to the positive supply. For recommended fuse
rating, refer to "Technical specifications" on page 17.
Power connector details
1 2
Unit socket (male)
Pin Purpose
1
+12/24 V DC
2
DC negative

Serial

The serial port provides input (Listeners) and outputs (Talkers) for the various interfaced
sensors. The port uses the IEC 61162 (serial balanced) standard.
IEC 61162 messages
For details about how to configure the serial ports, refer to the commissioning manual.
Sentence Description
THS True heading
status
HDT Heading true
VDM AIS VHF data-link
message
VDO AIS VHF data-link port 2 in
TTD Tracked target
data
TLB Target label
VBW Dual ground/
water speed
VHW Water speed and
heating
ZDA Time and date
GLL Geographic
position-
latitude and
longitude
GGA Global
positioning
system (GPS) fix
data
Wiring | R5000 radar processor Installation Manual
Cable plug (female)
Standard BAM
port 1 in port 1 in
port 1 in port 1 in
port 2 in port 2 in
port 2 in
port 2 out port 2 out
port 2 out port 2 out
port 3 in port 3 in
port 3 in port 3 in
port 4 in port 4 in
port 4 in port 4 in
port 4 in port 4 in
1 2
Legacy alert
port 1 in
port 1 in
port 2 in
port 2 in
port 2 out
port 2 out
port 3 in
port 3 in
port 4 in
port 4 in
port 4 in