Replacing The Light Bulb; Cleaning And Maintenance - Dometic COOLFREEZE CF35 Operating Manual

Cleaning and maintenance

I
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
6.11

Replacing the light bulb

➤ Press the switch pin (fig. 8 2, page 5) downwards so that the transparent part
(fig. 8 1, page 5) of the lamp can be removed at the front.
➤ Replace the light bulb.
I
NOTE
The LEDs in the light bulb must be aligned with the transparent part of
the lamp.
➤ Press the transparent part of the lamp back into the housing.
7 Cleaning and maintenance
!
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
•
Never clean the cooler under running water or in dish water.
•
Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
18
CF35, CF40, CF50
EN