Table of Contents
Advertisement
Network Bullet Camera·Quick Start Guide
Warnings
● Grounding:
The both internal and external earthing shall be connected
reliably.
Ground wire cross-sectional area of not less than the phase
connector cross-sectional area level, at least 4 mm
● All the electrical operation should be strictly compliance with
the electrical safety regulations, fire prevention regulations and
other related regulations of the nation and region.
● Make sure that the power has been disconnected before you
wire, install or
disassemble
● Do not connect several devices to one power adapter as
adapter overload may cause over-heating or a fire hazard.
● To avoid fire danger caused by electrostatic charge, never touch
or wipe the camera in explosive environment. Perform the
wiping and replacing accessories only under non-explosive
environment with the provided glove.
● When the camera is installed on wall or ceiling, the device shall
be firmly fixed.
● If smoke, odors or noise rise from the camera, turn off the
power at once and unplug the power cable, and then contact
the service center.
disassemble
the camera in explosive environment.
the camera.
Never
7
2
.
wire, install or
Advertisement
Table of Contents
