Perkins 1106C Genset Systems Operation Testing And Adjusting page 49

KENR6931
2. Ensure that the crankshaft and the camshaft
are locked in the correct position. Refer to
Disassembly and Assembly, "Gear Group (Front)
- Remove and Install" for the correct procedure.
Ensure that the fuel injection pump is locked in
the correct position. Refer to Disassembly and
Assembly, "Fuel Injection Pump - Remove" for the
correct procedure.
3. Install the idler gear (2). Refer to Disassembly and
Assembly, "Idler Gear - Remove and Install" for
the correct procedure.
4. Install the fuel injection pump gear (3). Refer to
Disassembly and Assembly, "Fuel Injection Pump
Gear - Install" for the correct procedure.
5. Make sure that the timing marks on the gears (1),
(2) and (3) are in alignment. If the timing marks are
not aligned, refer to Disassembly and Assembly,
"Gear Group (Front) - Remove and Install".
Testing and Adjusting Section
49