Perkins 1106C Genset Systems Operation Testing And Adjusting page 43

KENR6931
Illustration 41
Typical example
4. Remove the connection (1) from the top of the
secondary fuel filter base. Insert the end of the
connection into a suitable container.
5. Fit a suitable tube to the top of the secondary fuel
filter base. Insert the other end of the tube into a
suitable container.
6. Install new fuel filters. Refer to Operation and
Maintenance Manual for the correct procedure.
7. Prime the fuel system. Refer to Operation and
Maintenance Manual, "Fuel System - Prime" for
the correct procedure. Check that fuel is flowing
from the secondary fuel filter base. If there is no
flow of fuel, check the operation of the fuel transfer
pump. If there is still no flow of fuel, replace the
secondary fuel filter base. Refer to Disassembly
and Assembly, "Fuel Filter Base - Remove and
Install - Secondary Fuel Filter" for the correct
procedure.
8. Stop the engine. Refer to Operation and
Maintenance Manual for the correct procedure.
9. Remove the low pressure fuel line from the inlet
connection (2) of the secondary fuel filter base.
g01323442
Testing and Adjusting Section
43