Advertisement
Place the Bondtech Extruder in the
holder, use the top-clamp and the 2 M5
screws to secure the extruder, please
take not of the orienting tab of the top
clam, it shall fit inside the cutout on the
gearbox. Use the black foam insulator
between the motor and the mount, it can
either be installed on the motor or
delivered separately.
Connect the cable and the bowden tube,
make sure the bowden tube is pressed
down all the way into the extruder
housing, place the clip underneath the
plastic collar to prevent movement of the
bowden tube.
Ultimaker Installation manual QR V2.3
2019-02-18
8
Advertisement
