Advertisement
Simplify3D
If you are using Simplify3D as a slicer you will need to change a line in the start script section
that say M907 E1450 to M907 E1000.
If you are printing a part with extremely much retracts the motor can get quite hot, in order to
lower the temperature of the stepper motor you can lower the current to 1000 mA, the
pushing force of the extruder is more than enough also on this setting.
Good luck with your Bondtech Extruder!
If you have any questions, please contact us by email or telephone.
Lummervägen 5
33155 Värnamo
Sweden
e-mail:
order@bondtech.se
phone: +46702220193
paypal: martin@bondtech.se
web:
www.bondtech.se
VAT-registration number: SE556995564301
Ultimaker Installation manual QR V2.3
->
->
2019-02-18
11
->
- >
->
Advertisement
