Advertisement
To Wind the Bobbin
Release the balance wheel (E, Fig. 3, page
3) by turning the stop motion screw (D, Fig.
3, page 3) over toward you.
Place the bobbin on the bobbin winder spin-
dle (E, Fig. 6, page 7) and push it up closely
against the shoulder, having the small pin in
the spindle enter the hole in the side of the
bobbin. Put the spool of thread on the spool
pin (1, Fig. 5). Pass the end of the thread into
the thread guide (2, Fig. 5) then up into the
lower eyelet (3, Fig. 6) of the bobbin winder
thread guide, into the notch (4, Fig. 6) and
pass the thread through the hole in the left
side of the bobbin (5, Fig. 6) from the inside.
Press the bobbin winder pulley (B, FIG. 6)
down on the balance wheel hub and the latch
(C, Fig. 6) will drop down and hold it. Then
operate the treadle the same as for sewing.
Table of Contents
82387 No. 66
6
FIG. 5. MACHINE THREADED
FOR WINDING THE BOBBIN
Previous Page | Next Page
Advertisement
