Singer 82387 Instruction Manual page 20

ADJUSTABLE HEMMER
Hemming
Remove the presser foot and attach the
adjustable hemmer in its place as shown in
Fig. 25. This hemmer will turn hems from
3/16 inch to 1 inch wide. The adjustment is
made by loosening the thumb screw on the
hemmer and moving the slide to the right or
left until the hem turned is of the desired
width. Enter the edge of the cloth into the
hemmer under the scale and draw it back
and forth until the hem is formed, stopping
with the end under the needle. Lower the
presser bar and commence to sew, being
careful to guide cloth as to keep hemmer full.
Felling can also be done with the adjustable
hemmer
ADJUSTABLE HEMMER
Wide Hemming
To make a hem more than one inch wide take
out the thumb screw in the hemmer and
remove the slide and pointer; fold and crease
down a hem of the desired width; pass the
fold under the extension at the right of the
hemmer, and the edge into the folder as
shown in Fig. 26 and proceed to stitch the
hem.
Table of Contents
82387 No. 66
20
FIG. 25
FIG. 26
Previous Page | Next Page