Singer 82387 Instruction Manual page 18

FOOT HEMMER
Hemming and Sewing on Lace
Start the hem as previously explained, and
when it is well started raise the needle to its
highest point.
Raise the hemmer to relieve its pressure on
tile hem, pass the end of the lace through the
slot in the side of the hemmer, under the
back of tile hemmer and over the hem, as
shown in Fig. 22.
Take care that the hem is not displaced in the
hemmer and that the needle goes down
through the lace and hem together. Then let
down tile presser bar and guide the lace over
the front of the hemmer, keeping it well into
the slot.
Table of Contents
82387 No. 66
18
FIG. 22
Previous Page | Next Page