Singer 82387 Instruction Manual page 10

To Prepare for Sewing
With the left hand hold the end of the needle
thread, leaving it slack from the hand to the
needle.
Turn the balance wheel over toward you until
the needle moves down and up again to its
highest point, thus catching the bobbin
thread; draw up the needle thread and the
bobbin thread will come up with it through the
hole in the throat plate (see Fig. 12). Lay both
threads back under the presser foot.
To Commence Sewing
Place the material beneath the presser foot,
lower the presser foot and commence to sew,
turning the balance wheel over toward you.
To Remove the Work
Let the thread take-up lever rest at its highest
point, raise the presser foot and draw the fab-
ric back and to the left, pass the threads over
the thread cutter (A, Fig. 12) and pull down
lightly to sever them. Leave the ends of the
threads under the presser foot.
Table of Contents
82387 No. 66
FIG. 12. DRAWING UP THE BOBBIN THREAD
10
Previous Page | Next Page