Retrieving And Changing Special 2-Step Parameters For A Selected Job; General; Retrieving And Changing Special 2-Step Parameters For A Job - Fronius RCU 5000i Operating Instructions & Spare Parts

Retrieving and changing special 2-step parameters
for a selected job

General

The sequence of screens shown on the "clothesline" depends on the type of job selected.
"Special 2-step" screen only appears:
-
-
Retrieving and
1
changing special
2
2-step parame-
ters for a job
3
4
5
6
Optimizing and managing jobs: "Special 2-step"
screen
86
if the trigger mode is set to S2-step for the job selected
for MIG/MAG synergic jobs
Call up the "Optimizing & managing jobs" menu item
Whatever screen is showing, select "Group n°" parameter using the down (6) or up (7)
keys
Select desired group (0 - 99) using the adjusting dial (18)
Select "Job n°" parameter using the down (6) or up (7) keys
Select desired job (0 - 999) using the adjusting dial (18)
– If a job is selected from the next group, the group displayed also changes accord-
ingly.
Select "Special 2-step" screen by pressing the right arrow key (8)
– "Special 2-step" screen appears
Select the corresponding parameters
7
using down (6) or up (7) keys
Use the adjusting dial (18) to alter the
8
parameter value
– A parameter value can only be al-
tered within the defined setting
range. The setting range is high-
lighted.