Bosch GTS1031 Operating/Safety Instructions Manual page 13

1600A004FB 12-14 E_GTS1031 12/17/14 10:25 AM Page 13
10. Lower the front of the guard assembly 4 until
the metal "fork" is parallel with the table (Fig. 8).
11. Press down on the guard release lever 5 until
you feel and hear it snap into the locking posi-
tion. Check that the guard assembly is securely
connected (Fig. 8).
ATTACHINg THE ANTI-KICKbACK dEVICE
12. Attach the Anti-Kickback Device 7 into the flat
recessed area 8 of the riving knife 2 (Fig. 9).
13. Squeeze the compression pads 9 while nesting
the device into the flat area (Fig. 9).
14. Release the compression pads such that the
Anti-Kickback Device locks onto the riving knife
FIG. 9
Hint: Position the Anti-Kickback Device behind the
flat recessed area and slide it towards the front until
it drops into the recessed area – then release the
compression pins.
Note: The two attachments are independant of each
other, so the Anti-Kickback Device can be attached
before the Guard Assembly.
4
7
9
8
2
-13-
immediately behind the guard assembly. Check
that the attachment pin is securely connected
into locking hole. Carefully raise and lower the
pawls 10 – when letting go, the spring-loaded
pawls must come down and contact the table in-
sert (Fig. 9).
FIG. 8
5
9
10