Niles IntelliPad Installation & Operation Manual page 24

W M
A L L O U N T E D
Only the six Source
Select keys and the
Power key can be
programmed to use
the Press and Hold
feature.
Figure 19
Eligible keys for
the Press and
Hold feature
Programming a Press and Hold
Single IR Command
1. Press the PROGRAM button. The PROGRAM
LED, the IR/SEQ LED and the PAGE LED light
up red prompting you to select which "page"
the key you wish to teach is located.
2. Press and hold the POWER key. This selects the
Press and Hold page (the POWER LED lights
up red). The KEY LED lights prompting you
to select the key you want to learn a new
command.
3. Press one of the Source Select keys or the Power
key. In our example, you would press the
23
P
R O G R A M M A B L E
Source Select key labeled VCR. The ENT IR LED
(Enter IR) lights prompting you to issue the IR
command you want the IntelliPad to learn.
4. Press the key on the source component's remote
TUNER
control that you want the IntelliPad to learn. In
our example you would press the Power key
CD
on the VCR's remote control. The KEY LED
TAPE
lights confirming that the IR command has
VCR
been successfully learned by the IntelliPad.
LASER
5. Repeat steps 3 and 4 to program additional press
SAT and hold commands.
6. To exit the Program mode, press the PROGRAM
button twice (the PROGRAM LED will go out).
Programming a Press and Hold
Sequence
1. Follow steps 1-2 in the section Programming
the Sequence found on page 21.
2. When you are prompted to pick the Trigger
Page, press and hold the Power key for more
than one second. The status LED lights Red.
3. Press the Source Select key or Power key you
want as the trigger key for your press and hold
sequence.
4. Follow steps 5-7 in the section Programming
the Sequence found on page 21.
5. To exit the Program mode, press the PROGRAM
button twice (the PROGRAM LED will go out).
I R K S
E Y P A D Y S T E M