Niles IntelliPad Installation & Operation Manual page 21

W M
A L L O U N T E D
Erasing a Single IR Command
If you make a mistake, you can erase just a sin-
gle key anytime by following these steps:
1. Press the PROGRAM button. The PROGRAM
LED, the IR/SEQ LED and the PAGE LED light
up red.
2. Press and hold the ERASE button until all the
PROMPT LEDs light up, then release. The PRO-
GRAM LED begins to flash, warning you that
you are about to erase.
3. Select the Page, then the Key that corresponds
to the address of the IR command that you wish
to erase. This erases any IR code stored at that
address.
4. To exit the Program mode, press the PROGRAM
button (the PROGRAM LED will go out).
NUMBER
PAGE
System
TRIGGER
1
System
2
Tuner
3
Tape
4
CD
5
6
7
8
9
10
P
R O G R A M M A B L E
Building Sequences to Automate
Any System
Planning the Sequence
Begin by writing down the address (Page, Key)
of the key which will trigger the sequence.
Sometimes, it helps to write a note describing
the function of the command. A sequence can
have a maximum of ten steps. See Figure 17.
NOTE: The power command for the preampli-
fier/receiver is never manually programmed
into a sequence. The IntelliPad's Auto Power
Insert feature is enabled via the jumper labeled
Status Feedback.
KEY
Tuner
Tuner Tuner Input
Play Preset Station
Stop Tape Deck
Pause CD Player
I R K
E Y P A D
NOTES
Figure 17
Planning a sequence
S
Y S T E M
20