Niles IntelliPad Installation & Operation Manual page 20

W M
A L L O U N T E D
3. Press the key you want to teach. For example,
you may choose to teach the "Tuner input"
first. In this case, you would select the Source
Select key labeled "Tuner" . The ENT IR LED
(Enter IR) lights prompting you to issue the IR
command you want the IntelliPad to learn.
4. Press the key on the preamp's/receiver's remote
control that you would like the IntelliPad to
learn. Hold the remote control between 3
and 6 inches away from the sensor. Aim
directly at the IntelliPad's sensor. In our
example, you would press the Tuner input
select key on the remote control. The KEY
LED lights confirming that the IR command
has been successfully learned by the
IntelliPad.
5. Repeat steps 3 and 4 until all of the desired pre-
amp/receiver IR commands have been taught
to the IntelliPad.
6. Repeat steps 2-5 to program additional source
components.
7. To exit the Program mode, press the
PROGRAM button twice (the PROGRAM LED
will go out).
Programming Each of the Source
Component Commands Into IntelliPad
1. Press the PROGRAM button. The PROGRAM
LED, the IR/SEQ LED and the PAGE LED light
up red prompting you to select the "page"
19
P
R O G R A M M A B L E
that you want to teach the IR commands to.
(i.e. CD, Tape, Tuner, etc.)
2. Press one of the six Source Select keys. For
example, you may choose to teach the CD
page first. In this case, you would press the
Source Select key labeled "CD" . The KEY LED
lights prompting you to select the key you
will teach an IR command to.
3. Press the key you want to teach. For example,
you may choose to teach the "Play" key first.
The ENT IR LED (Enter IR) lights prompting
you to issue the IR command you want the
IntelliPad to learn.
4. Press the key on the CD's remote control that
you would like the IntelliPad to learn (in our
example you would press the "Play" key).
Hold the remote control between 3 and 6
inches away from the sensor. Aim directly at
the IntelliPad's sensor. The KEY LED lights
confirming that the IR command has been
successfully learned by the IntelliPad.
5. Repeat steps 3 and 4 until all of the desired
source component (CD in our example) IR com-
mands have been taught to the IntelliPad.
6. Repeat steps 2-5 to program additional source
components.
7. To exit the Program mode, press the
PROGRAM button twice (the PROGRAM LED
will go out).
I R K S
E Y P A D Y S T E M