Installation - Niles IntelliPad Installation & Operation Manual

W M
A L L O U N T E D

Installation

Overview
The IntelliPad is installed by following these
steps in order:
1. Install the electrical box (J-box) or plaster ring
(P-ring) in the usual manner.
2. Run the cables to the IntelliPad location. Label
all cables. See Installation Considerations.
3. Install the Source Labels.
4. Set the Status Feedback and Speaker Relay
jumpers to the correct configuration. (See
page 12).
5. Make the connections to the IntelliPad.
6. Secure the IntelliPad to the J-box or P-ring.
7. With power off, make the connections to the
IR main system unit and IR flasher. Then con-
nect the power and status feedback wall
adapters.
8. Program the IntelliPad. You can choose from
three programming options:
1. Manual programming
2. Memory transfer from a preprogrammed
IntelliPad
3. Memory transfer from a personal computer
using the Niles IntelliFile PC Transfer and
Storage System.
9. Secure the Decora faceplate to the IntelliPad.
11
P
R O G R A M M A B L E
Installing the Source Labels
Included with the IntelliPad is a sheet of precut
and preprinted labels for your convenience. To
install the labels follow these steps:
1. Holding the IntelliPad as shown in Figure 7,
remove the white Decora style inserts on the
face of the IntelliPad by pulling straight back
away from the IntelliPad. The inserts are held
in by friction fit pegs and pop free very easily.
2. Before installing labels determine which color
(bone or white) Decora-style insert is appropri-
ate for your installation and reserve them in a
convenient place.
3. Detach labels you would like to use. Reserve
them in a convenient place.
4. Remove the six plastic label plugs from their
bag and place them next to the labels.
I R K S
E Y P A D Y S T E M
Figure 7
Removing the
Decora inserts