Sony MSB-2000 Operation Manual page 80

List of Menus
Item number Category
T031 status
T032 status
T033 status
T034 status
T035 status
T041 status
T042 status
Item Arguments
pict_size –
ref –
sdi_sdti –
asi –
cascade_asi –
link_status –
link_speed –
Function
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, during selection/decoding of a TS
stream, outputs the video ES pict_size
(image frame).
The output value is "720×480" "544×480"
"480×480" "352×480" "352×240" "720×512"
"720×608" "720×576" "544×576" "480×576"
"352×576" "352×288" or "Other".
In cases other than this, outputs "--------".
In all modes, indicates whether there is an
input on the ref connector.
When present: "present"
When absent: "absent"
In tx-rx/tx-rx (cm) sdi_to_asi mode,
indicates whether there are SDI signals on
the sdi/sdti-cp connector.
When the input is present: "present"
When no input is present: "absent"
In sdti-cp_to_asi mode, indicates whether
there are SDTI-CP signals on the sdi/sdti
connector.
When the input is present: "present"
When no input is present: "absent"
In asi_to_sdi/asi_to_sdti-cp mode, outputs
"--------" signifying that this is invalid.
In tx-rx/tx-rx (cm) asi_to_sdi/asi_to_sdti-cp
mode, indicates whether or not there is an
input on the ASI connector.
When present: "present"
When absent: "absent"
In asi_to_sdi/asi_to_sdti-cp mode, outputs
"--------" signifying that this is invalid.
In the case of mux on, whether or not there
is an input on the Cascade ASI input
connector.
When present: "present"
When absent: "absent"
When mux off, outputs "--------" signifying
that this is invalid.
In all modes, displays the connection
status of the MSBA-20IP 100BASE-TX
connector.
If connected: "up"
If not connected: "down"
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In all modes, when link_status is "up," the
communications speed is displayed, shown
as:
For a 10 Mbps connection: "10"
For a 100 Mbps connection: "100"
If link_status is "down," "--------" is output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
80