On-Screen Display Overview - Sony MSB-2000 Operation Manual

On-Screen Display Overview

On-Screen Display Overview
With this unit, you can use the display on a monitor
screen connected to the SDI MON (SUPER) connector
to monitor information such as packet IDs, or to select
an input program.
The on-screen display (OSD) shows a main menu,
with a number of submenus, relevant information, and
an input program selection menu.
For menu operations, use the MENU button, ENTER
button, and cursor keys on this unit (see the illustration
on page 13).
Settings for OSD and operation
Use the following procedure.
1
Power on the monitor.
2
Press the MENU button.
The MENU button lights, and the menu appears in
the display window.
3
Press the V key, and display the "S:osd" menu.
4
Press the B key.
The menu item "S001:display" appears.
• When this is set to "off," continue to step 5.
• When this is set to "on," continue to step 7.
Note
In tx-rx (cm) mode, this menu item is always set to
"on."
5
Press the ENTER button.
The "off" indication and the ENTER button flash.
6
Press the v key, to select the "on" setting, then
press the ENTER button.
The ENTER button goes off, and the OSD appears
on the monitor screen.
The content of the OSD depends on the operating
mode of the unit.
Submenus
MSB-2000
MAIN MENU
-DECODER-
RX MONITOR
I/O STATUS
RX STATUS
-STREAM
-TIMING
-VIDEO
-AUDIO
DECODE STATUS
SYSTEM INFO.
SELECT v V
INPUT PROGRAM SELECT
200 201 202 203
204 205 206
b B
SELECT
Input program
selection menu
7
Press the V key.
The menu item "S002:control" appears.
8
Press the ENTER button.
Using the buttons and cursor keys on this unit, you
can make submenu selections and input program
settings on the monitor.
To select a submenu
Press the V key or v key, to move the cursor to the
desired submenu.
The information for the selected submenu appears on
the right of the screen.
Note
The submenus can only be displayed; it is not possible
to change the settings.
To change the input program setting (INPUT
PROGRAM SELECT)
Press the b key or B key, to move the cursor to the
desired input program. While the cursor is moved, it
appears white.
When you press the ENTER button, the cursor shows
red and the desired input program is selected. At the
same time, the selected input program submenu
information appears.
Relevant information
RX MONITOR
PROGRAM NUMBER 200
VIDEO RATE 12.000 Mbps
AUDIO INDICATOR
CH1 PRESENT
CH2 PRESENT
CH3 ABSENT
CH4 ABSENT
CH5 ABSENT
CH6 ABSENT
CH7 ABSENT
CH8 ABSENT
16