Table of Contents
Advertisement
Names and Functions of Parts
Front panel
1 POWER switch
This powers the unit on or off. When the " ` " side of
the switch is pressed the power is on, and when the
"a a a a a " side is pressed the power is off.
2 PANEL INHI (panel inhibit) indicator and
selector switch
To disable the MENU button, ENTER button, and
cursor keys (v, V, b, B), slide this switch up. (The
indicator lights amber.)
3 IN/OUT indicators
The indicators light or flash green corresponding to the
input/output signals selected in the "B:mode" menu.
IN indicator lit (green): The input signal selected in
the "B:mode" menu is detected.
IN indicator flashing (green): The input signal
selected in the "B:mode" menu is not detected.
OUT indicator lit (green): Selected in the "B:mode"
menu.
Note
When the MSBA-20IP is installed, the validity of the
OPTION IN/OUT indicators depends on the settings in
the "B:mode" menu and menu items "E001:rtp_tx"
and "E021:rtp_rx". Note that when a destination is not
found, the OPTION OUT indicator flashes.
For more details of the menus, see the List of Menus (page
36).
4 REF IN (reference input) indicator
Lit (green): In the menu item
"C002:frame_sync_ref," ref_in is selected, and a
composite [video] signal such as black burst is
connected to the REF IN connector.
Flashing (green): In the menu item
"C002:frame_sync_ref," ref_in is selected, but a
composite [video] signal such as black burst is not
connected to the REF IN connector.
Note
To the REF IN connector, connect a signal such as
black burst whose amplitude does not fluctuate.
For more details of the menus, see the List of Menus (page
36).
5 VIDEO SYSTEM 525/625 indicators
525 indicator lit (green): In the menu item
"M001:video_system" 525-line format is selected.
625 indicator lit (green): In the menu item
"M001:video_system" 625-line format is selected.
For more details of the menus, see the List of Menus (page
36).
6 LAN indicator
Lit (green): The unit is connected to the LAN
(10BASE-T).
Flashing (green): The unit is connected to the LAN
(10BASE-T), and data is being transmitted.
7 ALARM indicator
If a problem is detected during operation, an alarm
signal is output from the ALARM connector on the
read panel, and this indicator lights red.
8 Display window
After powering on, an initial screen appears for about
2 seconds. Next, the STATUS screen appears.
Press the MENU button to display the menus and
setting confirmation screens.
For details of the display at power on, see the section
"Display when the unit is powered on" (page 13).
9 MENU button
Press the MENU button to light it, and show the menus
and setting confirmation screens in the display
window. Press once more to switch to the STATUS
screen, and turn the button off.
At the point of confirming a setting, to cancel the
change, press the MENU button to return to the
previous settings.
For more details of the menus, see the List of Menus (page
36).
0 ENTER button
When a setting is shown in the display window, press
this button to select or confirm it.
When menu operations are enabled on the monitor
screen, this also confirms the selection of an input
program.
8
Advertisement
Table of Contents
