Operation - Husqvarna R 418Ts AWD Operator's Manual

Hide thumbs Also See for R 418Ts AWD:
Table of Contents

Advertisement

Available languages

Available languages

Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 10 ).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
Do a check of the fuel level before each use and
refuel if necessary.
Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
To adjust the seat
WARNING: Do not adjust the seat during
operation of the product.
The seat can be tilted forward. It can also be adjusted
forward and rearward.
To adjust the seat forward and rearward, push the
lever below the front edge of the seat to the left.
Move the seat to the required position.
14

Operation

To adjust the seat springs, move the rubber stops
below the seat as given in the illustration. Put the 2
stops in the front, middle or rear.
Fuel safety
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The product has one drive system lever for the front axle
and one for the rear axle. The drive system lever for the
rear axle is found behind the left rear wheel.
The drive system lever for the front axle is found behind
the left front wheel.
522 - 002 -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 422ts awd

Table of Contents