Husqvarna R 418Ts AWD Operator's Manual page 18

Maintenance
Clean the inner surface of the cutting deck, around the
blades
Clean around the engine and the muffler
Make sure that the cold air intake of the engine is not
blocked
Make sure that the safety devices are not defective
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Do a check of the parking brake
Clean the inner surfaces of the frame tunnel
Lubricate the seat slides
Clean the cutting deck, below the belt covers and below the
cutting deck
Make sure that the tire pressure is correct
Replace the engine oil
Replace the oil filter
Clean the air filter
Replace the inner air filter
Replace the air filter cartridge
Replace the fuel filter
Do a check of the headlights, replace broken lamps
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster
Lubricate the joints and bearings on the cutting deck
Lubricate the pedal system in the frame tunnel
Lubricate the chains in the frame tunnel
Lubricate the parking brake cable
Lubricate the throttle cable
Lubricate the choke cable
Lubricate the cable for the hydrostatic transmission
Do a check of the V-belt on the cutting deck
18
Daily, before Weekly
operation
X
X
X
X
*
X
X
X
X
X
X
X
Maintenance interval
in hours
25 50 100 200
X
X X
X X
X X
X X
X X
X
X X
X X
X X
X X
X
X
X
X
X
X
X
O
522 - 002 -