Husqvarna R 418Ts AWD Operator's Manual page 28

7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Note: See Technical data on page 35 of engine oil
recommended. Do not mix different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To change the engine oil and the oil
filter, R 418Ts AWD
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for
more than 1–2 minutes before you drain the
engine oil. The engine oil becomes very hot
and can cause burn injuries. Let the engine
become cool before you drain the engine oil.
WARNING: If you spill engine oil on your
body, clean with soap and water.
1. Put a container below the oil drain plug on the left
side of the engine.
2. Remove the dipstick.
3. Remove the oil drain plug.
4. Drain eller the oil into the container.
28
5. Attach the oil drain plug and tighten it.
6. Turn the oil filter counterclockwise to remove it.
7. Lightly lubricate the rubber seal on the new oil filter
with new oil.
8. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
9. Fill with new oil as given in
engine oil level, R 418Ts AWD on page 27 .
10. Start the engine and let it idle for 3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Do a check of the oil level and fill with oil to
compensate for the oil held in the new oil filter.
Note: For safe disposal of used engine oil, see
on page 34 .
To change the engine oil and the oil
filter, R 422Ts AWD
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for
more than 1–2 minutes before you drain the
engine oil. The engine oil becomes very hot
and can cause burn injuries. Let the engine
become cool before you drain the engine oil.
WARNING: If you spill engine oil on your
body, clean with soap and water.
1. Put a container below the oil drain plug on the left
side of the engine.
2. Remove the dipstick.
To do a check of the
Disposal
522 - 002 -