Table of Contents
Advertisement
PROGRAMMING
P
rogramming the converter.
For the correct operation of this system it must be programmed as indicated in the following
instructions:
Programming methods
With an IT-4N telephone interface (Divert Mode Always Enabled)
Without the telephone being connected to the output line to telephones of the IT-4N telephone
interface.
1
1
2
3
4
5
6
7
8
9
0
#
*
3
6
9
#
3
6
9
#
1
2
3
4
5
6
7
8
9
0
#
*
Master
The converter should be programmed as slave when it is installed in an apartment with a
monitor.
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
whether they are monitors, telephones or converters. The programming of the converter is
complete.
Make a call to check that it has been successfully programmed.
Having completed the programming set the Door panel's programming switch to OFF, or
exit the configuration mode (coded panel) by pressing the C button.
Access the door panel programming mode. If it is a door panel
with pushbuttons set dip switch no. 2 from the EL 500 module to
ON, and if it is a coded panel press the key button followed by the
3
1
5
installer Pin (from factory: 1315).
From a telephone on the PABX, call the IT-4N extension and
establish audio communication. Enter "##9" code to access
the programming mode of the CD-PLUS/4N protocol converter.
(In the case of a coded door panel you have 10 seconds to enter
this code starting from the moment communication has been
established).
To show that the system is ready for programming, the door
panel and handset will emit a tone, and the green LED on the
protocol converter will blink slowly.
Press the door panel push button that will call this converter, or in
the case of a coded panel, enter the apartment code and press
the button
emit tones and the converter's green LED will blink quickly.
With the handset lifted:
1
2
3
If programming the converter as master, press the " " push button
4
5
6
and replace the handset.
7
8
9
If programming it as slave, press push button 5 followed by push
0
#
*
button " " and finally, replace the handset.
*
Slave
. At this moment the door panel and handset will
6
*
Advertisement
Table of Contents
