It is strongly forbidden to open the cover of the device, there is high voltage inside. If some problems occur, please read the operation manual carefully or address an authorized service center. For the list of authorized service centers please go to www.sven.fi. •...
Wall-Mounted Automatic Voltage Regulator WORKING UL ATING PROTECTIN Fig. 2. Control panel OF F INPU T UNDEL AY DELA Y Fig. 1. Front/back panel VR-S 3000 Fig. 3. Rear panel 4. DESCRIPTION (see. Fig. 1-3) a WORKING: LED (green) lights up when there is a input voltage b REGULATING: LED (yellow) lights up when operating stabilizer for rise/fall if the input voltage display is turned off c PROTECTING: LED (red) lights up in case of an accident (switch-protection against high/low...
AVR. For the VR-S3000 electrical connection should only be performed by a qualified technician. Before installing the AVR, please make sure that total power of all consumers is lower than AVR output power.
Wall-Mounted Automatic Voltage Regulator Attention! It is recommended to switch off the AVR and every connected consumer-device when the power supply is dropped. 8. PAUSE FUNCTION • The Pause mode feature is designed to protect equipment in case of frequent drops of the mains supply.
Mounting dimensions, mm x = 380; y = 181.5 Notes: • Technical specifications given in this table are supplemental information and cannot give occasion to claims. • Technical specifications are subject to change without notice due to the improvement of SVEN production.
Page 8
Роуд, № 02-02, Сингапур, 427447. Произведено под контролем «Свен Скандинавия Лимитед», 48310, Фин- ляндия, Котка, Котолахдентие, 15. Сделано в Китае. Manufacturer: SVEN PTE. LTD, 176 Joo Chiat Road, № 02- 02, Singapore, 427447. Produced under the control of Oy Sven Scandinavia Ltd. 15, Kotolahdentie, Kotka, Finland, 48310.
Need help?
Do you have a question about the VR-S3000 and is the answer not in the manual?
Questions and answers