To Start The Beneloc Program - Benefon DRAGON TDP70WN Service Manual

to install the BeneLoc Program. The Program suggests the following: C:\Bene-
App\BeneLoc. Accept the drive and directory by clicking Next button. You can also
type your own directory for BeneLoc Program.
The Setup Program creates all necessary directories and subdirectories to your
computer. Setup Program also creates its own group window in Program Manager.

4.0.2 To start the BeneLoc program

Connect the Service Localbox to serial port of your computer, which is called COM1
or COM2. The serial ports are usually located in the back of your computer, and
more precise instructions can be found in the manual accompanying the computer.
Adjust the Power Supply voltage to 4.0 Vdc. Connect the Service Localbox to the
Power Supply.
Connect the Service Adapter to the phone. Plug the cable with flat connector into the
connector at the bottom of the phone. When the cable has been connected and the
phone is switched on, the phone should be in LOCAL mode. You can test this by
pressing arrow button. There should be ***BENEFON*** on the display, if not, clean
connectors and try again. When phone is in LOCAL mode you can start the Bene-
Loc Program.
To start the BeneLoc Program, double click the BeneLoc icon.
In the BeneLoc Startup window, first select the correct serial port. Then, you have to
select type of the phone. You can also use the Autodetect option. After selection
click OK to start BeneLoc Program. When operating without external power supply
the phone may be on sleep mode and registration fails. You can wake up the phone
by pressing some buttons on the phone.
3dp_70gb
Product: TDP70WN /
5.9.2000
BeneLoc
2