Charging The Battery; Turning The Phone On; Start-Up Information - Benefon TWIG DISCOVERY User Manual

Charging the battery

1. Plug the charger cable in the bottom connec-
tor of the phone (round hole on the right
hand side).
2. Plug the charger into the mains outlet.
3. Charging starts automatically. As a sign of
ongoing charging process, the battery symbol
starts moving on the upper right hand side.
When the phone is fully charged, or the
phone is disconnected from a charger, the
movement will stop showing current charge
level.
4. You can operate the phone during charging.
However, if the battery is totally empty, it
might take several minutes before the bat-
tery symbol is displayed and the phone can
be used.
Note that battery will reach its full capacity only
after two or three complete charges.
For more information about batteries, please see
battery information on page 86
ries are available for your phone. on page 88.
and following accesso-

Turning the phone on

1. Press and hold down the uppermost side key
N
.
2. If the phone requests for PIN code or any
other codes, key in the correct code and
press the left function key
a mistake, press the right function key
Clear as many times as needed to remove the
incorrect digits.
3. The phone enters stand-by mode.
The power of the phone can turn on automatically
to stand-by mode when the
vated and it reaches the set time. When a preset
Alarm is activated, the phone turns on to a special
alarm mode where setting off the snooze is pos-
sible.

Start-up information

Depending on settings, inserted cards, or status
of the GSM network, you may see some start-up
or standard display information, such as logos,
symbols, texts, notifications or
stand-by mode. Some examples:
• If the phone has been a long time without
battery, time and date are prompted.
GETTING STARTED
.
. If you make
-
Auto switch on is acti-
elements in
7