Troubleshooting And Repair - Storm Surge SS20ST Operator's Manual

Pump Maintenance
Always shut off the engine, allow the engine to cool, and
remove the spark plug before performing any maintenance.
During freezing weather, open the drain port and allow all the
water in the pump to drain. This will prevent damage to the
pump when the water freezes. If the pump will be stored for
a month or more, drain the water from the pump and follow
the engine manufacturer's recommendations for long-term
storage.
NOTE: The Viper engine is equipped with a low oil shut
off sensor. The engine will shut down and will not
restart if the oil level becomes low.
Engine Maintenance
Good maintenance is essential for safe, economical, and
trouble-free operation. It will also help reduce air pollution.
Please read the maintenance schedule in the
accompanying engine manual and observe these
recommendations to extend the life of your pump.
The engine manual also outlines routine inspection
procedures and simple maintenance procedures using
basic hand tools. Service tasks that are more difficult, or
require special tools, are best handled by professionals and
are normally performed by a technician or other qualified
mechanic.
Maintenance, replacement or repair of the emissions
control devices and systems may be performed by any
non-road engine repair establishment or individuals.
However, items must be serviced by an authorized dealer
to obtain "no charge" emissions control service.
If you operate your engine under unusual conditions, such as
sustained high-load or high-temperature operation, or use
in unusually wet or dusty conditions, consult your servicing
dealer for recommendations applicable to your individual
needs and use.
Transporting Your Pump
1. After using the pump and before transporting it in a truck
bed, screw the fuel cap on (clockwise) tightly. The fuel
cap will not leak during transporting if fuel cap is tight.
Never transport engine inside an enclosed space within
a vehicle. Fuel or fuel vapors may ignite causing serious
injury or death.
2. If fuel is present in the fuel tank, transport in an open
vehicle in an upright position.
3. If an enclosed vehicle must be used, remove fuel into an
approved red fuel container. DO NOT siphon by mouth.
Check for parts online at www.stormsurgepumps.com or call 800-345-6007 M-F 8-5
SS20ST and SS30ST Water Pumps
4. Run engine to use up the fuel in the carburetor and fuel
tank. Always run engine in a well ventilated area. Engine
can run for several minutes due to its efficient design.
5. Wipe away any spilled fuel from engine and pump. Allow
to dry.
6. Fuel cap should be tightly secured before transporting
pump in a vehicle.
Flushing the Pump Housing
1. After use, remove the pump drain plug and allow the
water to drain from the pump housing.
2. Remove the pump primer cap and flush the pump
housing with clean water.
3. After all water has drained from the pump housing,
replace the primer cap and drain plug.

TROUBLESHOOTING AND REPAIR

Service Information
At Storm Surge we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life for
your machine. Most repairs will be minor, and easily fixed by
following the suggestions in the "Troubleshooting and Repair"
section and Table 1. Troubleshooting Guide.
This guide will help you pinpoint the causes of common
problems and identify remedies.
For more complicated repairs, contact your place of purchase
or Storm Surge for an authorized service center in your area.
Storm Surge will make the necessary repairs if a service center
is not available. A parts breakdown is included in toward the
end of the manual.
We will always be glad to answer any questions you have, or
help you find suitable assistance. To order parts or inquire
about warranty, call, write or e-mail us using the contact
information found in the "Troubleshooting and Repair" section.
Ordering Replacement Parts
Parts can be obtained from the store where the pump was
purchased or direct from the factory. To order parts visit www.
stormsurgepumps.com or call 1-800-345-6007.
For other general questions, you can e-mail us at info@
ardisam.com.
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number
Spare Parts
Only use approved Storm Surge spare parts.
Operator's Manual
13