Port Connections; Base-T Switch Ports; Internal Switch Ports - 3Com MSH 1005 User Manual

SmartAgent support
SNMP with IP and IPX protocols
RMON
Repeater and Bridge MIB
Broadcast storm control
Easy software upgrades
BOOTP
Local management

Port Connections

10BASE-T Switch Ports

Eight fixed ports each configured as MDIX provide 10Mbps bandwidth
to each attached end-station. Maximum segment length is 100m
(328ft) over grade 3, 4 or 5 twisted pair cable.

Internal Switch Ports

As well as switch ports located on the front panel of the Switch 1005,
internal backplane connections provide an additional four switch
ports. These ports are enabled and disabled through management or
using the set of links LK1 to LK5 located on the Switch 1005.
Three of these ports provide switched connections to the three
10Mbps repeater backplanes located in the MSH chassis, and therefore
to any modules connected to the same backplane.
The fourth internal switched port provides a connection to the Fast
Ethernet backplane, and therefore to any other Switch 1005 modules
installed in the chassis.
Locating and setting links is described in
Switch 1005"
DUA1840-0AAA01
in Chapter 2.
About the MSH Switch 1005
"Setting the Links on the
1-3