Important - Initial Set Up; Programming; Built-In Shows - Qtx PAR100 User Manual

Important - Initial set up

Before commencing any programming check that the unit is in master mode.
Programmes will not be stored if in slave mode.
To check, proceed as follows:
Press the MENU button repeatedly until the display shows
•
The display will show
•
[nASt]
If it shows
•
and holding MENU for 5 seconds.
If the display shows [SL1],
•
until it shows [nASt].
Press ENTER to select and then press and hold MENU for 5 seconds to store.
•

Programming

Programmes can be accessed from the 4 manual control buttons on the rear panel.
Please refer to appendix 1 where indicated.

Built-in shows

Pre-programmed auto-colour jump show
Press MENU repeatedly until the display shows
•
ENTER.
Using the UP and DOWN buttons select
•
The display will show [yeS]. Press ENTER to confirm the setting and press and hold MENU for
•
5 seconds to save the program.
NB. The relative duration of the primary colours in the above show can be tailored to suit the
application. To alter the duration, proceed as follows:
Press MENU repeatedly until the display shows
•
ENTER.
The display will show
•
DOWN buttons to select a different colour, followed by ENTER.
The display will show a number between
•
in a show, a colour set to 125 will only show for half as long as a colour set to 250.
Use the UP and DOWN buttons to set the duration followed by ENTER.
•
Use the UP and DOWN buttons to select another colour if required followed by ENTER.
•
Change the duration as detailed above followed by ENTER.
•
Press and hold MENU for 5 seconds to save the settings.
•
Sound assisted show
Press MENU repeatedly until the display shows
•
ENTER.
Using the UP and DOWN buttons select
•
The display will show [yeS]. Press ENTER to confirm the setting and press and hold MENU for
•
5 seconds to save the program.
Colour scroll show
Press MENU repeatedly until the display shows
•
ENTER.
Using the UP and DOWN buttons select
•
The display will show the fade speed which will be between fast
•
If necessary, use the UP and DOWN buttons to alter the speed followed by ENTER.
•
The display will show [FAde].
•
Press and hold MENU for 5 seconds to save the program.
•
[SL 1], [SL 2], [SL
then it is already in master mode in which case exit this routine by pressing
2], [SL 3]
[SL
[AUto]
[ red]. Press ENTER if red is the colour to be adjusted or use the UP and
[125]
[Soun]
[FAde]
[SLnd]
3], [SL 4] or [nASt].
[SL 4]
or press the UP or DOWN button repeatedly
[Shnd]
(refer to appendix 1) followed by
from the sub menu followed by ENTER.
[bALA]
(refer to appendix 1) followed by
[ 255]
and which is relative to the duration, ie
[Shnd] (refer to appendix 1) followed by
from the sub menu followed by ENTER.
[Shnd] (refer to appendix 1) followed by
from the sub menu followed by ENTER.
[SP 1]
followed by ENTER.
and slow [SP 8].