Advertisement
Clean DCFT Release Sheets and Club & Conveyor Belts
4
Remove wire bun chute and
clean.
• Lift chute at an angle,
lifting rear of chute and
then pulling chute forward
out of toaster.
• Spray a clean, sanitizer-
soaked towel with
approved detergent
solution or McDonald's
DR Concentrated
Disinfectant Cleaner.
• Use the towel to clean the
wire bun chute.
• Use the towel to clean all
exterior areas of the
toaster.
Chemicals
Sanitizer solution, Detergent
solution or McDonald's DR
Concentrated Disinfectant
Cleaner
(continued)
5
Clean landing zone and
reinstall wire bun chute.
• Spray a clean, sanitizer-
soaked towel with
approved detergent
solution or McDonald's
DR Concentrate
Disinfectant Cleaner.
• Use the towel to clean the
Pick-Up Zone.
• Spray all areas of the Pick-
Up Zone with SolidSense
Sanitizer and allow to air
dry.
Chemicals
Sanitizer solution, Detergent
solution or McDonald's DR
Concentrated Disinfectant
Cleaner
• Install wire bun chute by
sliding the wire bun chute
over the landing zone and
into the toaster.
• Position the chute so that
the rear of the chute is
secured by 2 posts at the
rear of the toaster.
NOTE: Front edge of the wire
bun chute should be
positioned at the edge of the
toaster landing zone.
Proper installation of wire bun
chute is shown above right.
Improper installation of wire
bun chute is shown below
right.
©McDonald's Corporation · Planned Maintenance Manual
527-502revC_EN 01/2014
Page 3 of 4
Advertisement
