Advertisement
Clean DCFT Release Sheets and Club & Conveyor Belts
2
(continued)
• Spray a clean, sanitizer-
soaked towel with
approved detergent
solution or McDonald's
DR Concentrated
Disinfectant Cleaner
solution and use to wipe
release sheet clean.
• Clean the entire surface of
the release sheet.
• Immediately rinse the sheet
with a clean, sanitizer-
soaked towel.
• Flip the release sheet over
and repeat cleaning
instructions.
• Rinse this side of sheet.
Chemicals
Sanitizer solution, Detergent
solution or McDonald's DR
Concentrated Disinfectant
Cleaner
• Install release sheet, making
sure that sheet is centered
over platen and the crease in
sheet is centered.
• Insert the release sheet over
the center bar of the in-feed
cover with one end of the
sheet in the Crown slot and
one end in the Heel slot.
• Position the crease on the
release sheet on top of the
in-feed chute center bar,
making sure that the sheet
corners are not curled
exposing the platen.
• Check to see that 12.7 mm
(1/2") of release sheet
extends below each side of
the platen.
NOTE: If 12.7 mm (1/2") of
the release sheet does not
extend below the bottom of
the platen, then the sheet is
not properly positioned.
NOTE: Make sure release
sheet is completely dry before
installing.
NOTE: When installing
release sheet, you may flip
inside-out and use the other
side if needed.
(continued)
3
Clean front and rear conveyor
and club belts.
• With power off, remove
gloves from hands to
unscrew and lift lid and
open front conveyor door.
• Put heat-resistant gloves
back on to clean.
• Using the sanitizer-soaked
towel, clean the front main
conveyor and club belts.
• Close front door, power
unit ON, count 13 seconds
to reveal unclean side of
belt, power unit OFF, open
door and repeat cleaning
using the sanitizer-soaked
towel.
• Close door, power unit ON,
count 13 seconds again,
power unit OFF, open door
and repeat cleaning.
• Wipe down the inner panel
of the conveyor access
door with a clean,
sanitizer-soaked towel
sprayed with approved
detergent solution or
McDonald's DR
Concentrated Disinfectant
Cleaner.
• Repeat the belt cleaning
process for rear main
conveyor belt, rear club
belt and rear inner panel.
Chemicals
Sanitizer solution, Detergent
solution or McDonald's DR
Concentrated Disinfectant
Cleaner
• Close the conveyor access
door and secure.
• Re-tighten top cover
screws.
©McDonald's Corporation · Planned Maintenance Manual
527-502revC_EN 01/2014
Page 2 of 4
Advertisement
