McConnel ROBOCUT Operator's & Parts Manual page 36

Engine Oil Replacement and Filter Change
Oil Capacity: 6.1L without filter
6.6L with filter
Oil Type: MOBIL SUPER 3000 X1 5W40 (E2022MB05W40)
The procedure for changing the engine oil and filter is as follows;
 Park the machine on a firm level site.
 Remove drain plug and release the oil into a suitable container – ensure the container used
has sufficient capacity for the amount of oil.
 Once all the oil has been released, replace drain plug and torque to 34.5Nm.
 Unscrew and remove the engine oil filter ►
 Take the new filter and smear some engine oil on the rubber seal before fitting – screw the
filter hand tight, then turn it approximately a further ¾ of a turn.
 Remove filler cap and slowly refill with 6.6L of MOBIL SUPER 3000 X1 5W40 engine oil.
 Replace filler cap and start the engine.
 Run engine for 5 minutes or so and stop for a further 3 minutes before checking the oil level
is correct.
NOTE: Used engine oil is both a dangerous waste and a precious raw material; collect it in a
suitable container and recycle it. Never pour waste oil into drains or waterways – it is harmful
and illegal.
Engine oil drain plug location
29