Troubleshooting - Eizo DuraVision FDF2405W User Manual

Troubleshooting

●
No picture
If a problem still remains after applying the suggested remedies, contact your local EIZO representative.
1. No picture
• Power indicator does not light.
• Power indicator is lighting blue.
• Power indicator is lighting orange.
• Power indicator flashes orange and blue.
2. The message below appears.
• This message appears when no signal is input.
Example:
• The message shows that the input signal is out
of the specified frequency range. (Such signal
frequency is displayed in magenta.)
Example:
fD: Dot clock
fH: Horizontal scan frequency
fV: Vertical scan frequency
8
Problem Possible cause and remedy
• Check whether the power cord is connected properly.
• Turn the main power switch on.
• Press .
• Turn off the main power, and then turn it on again a
few minutes later.
• Increase "Brightness" and/or "Gain" in the Adjustment
menu.
• Switch the input signal with
• Operate the mouse or keyboard.
• Check whether the PC is turned on.
• The device that is connected using DisplayPort has a
problem. Solve the problem, turn off the monitor, and
then turn it on again. Refer to the User's Manual of
the output device for further details.
This message appears when the signal is not input
correctly even when the monitor functions properly.
• The message shown left may appear, because some
PCs do not output the signal soon after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected
properly.
• Switch the input signal with
• Check whether the PC is configured to meet the
resolution and vertical scan frequency requirements
of the monitor ("Compatible Resolutions" in the Setup
Manual.).
• Reboot the PC.
• Select an appropriate setting using the graphics
boards utility. Refer to the User's Manual of the
graphics board for details.
.
.