ABH 6830 Series Installation Instructions

6830 SERIES REVERSE EXIT ONLY
COVER
(2) 8-32 X 3/8"
PHILLIPS FLAT HD. M.S.
PULL SIDE SHOWN
FOR EXAMPLE
MAKE CERTAIN BOLT
BEVEL FACES THE
DIRECTION OF DOOR
CLOSING
(2) #8 OR 8-32 SCREWS
INSTALLATION INSTRUCTIONS
1. PUSH/PULL LATCHES ARE ASSEMBLED FOR RIGHT HAND AND LEFT HAND DOORS. BE SURE CORRECT SIDE
MATCHES DOOR APPLICATION.
2.
PLACE LATCH BOLT UNIT IN DOOR MAKING SURE BOLT BEVEL FACES DIRECTION OF DOOR CLOSING.
ATTACH FRONT WITH TWO (2) #8 OR 8-32 SCREWS DEPENDING ON DOOR.
3.
POSITION LEVER ASSEMBLY SO THAT LOCATING PIN AND CAM ARM ENTER INTO CORRESPONDING HOLES IN
LATCH BOLT UNIT. ATTACH LEVER ASSEMBLY BY THRU BOLTING ONTO EXIT ONLY PLATE WITH FOUR (4)
#10-32 X 1-1/2" PHILLIPS PAN HD. M.S. FOR PURPOSE OF ALIGNMENT DO NOT TIGHTEN SCREWS UNTIL ALL
FOUR (4) SCREWS HAVE BEEN STARTED.
4. APPLY COVERS AND FASTEN WITH (2) 8-32 X 3/8" FLAT HD. M.S. FOR EACH COVER.
5.
INSERT DUST BOX IN FRAME MORTISE AND ATTACH STRIKE WITH TWO (2) #8 OR 8-32 SCREWS.
TO CHANGE DIRECTION OF PUSH OR PULL HANDLE
NOTE: REVERSE INSTALLATION INSTRUCTIONS #4 & # 3 THEN CONTINUE
WITH INSTRUCTIONS 1, 2 & 3 BELOW.
1. REMOVE THE (2) 10-32 SHOULDER BOLTS WITH SPRINGS THAT SECURE
THE CAM HOLDER ASSEMBLY, NOTE THE DIRECTION OF THE LOCATING
PIN BEFORE STARTING.
2.
ROTATE THE CAM HOLDER ASSEMBLY 180°.
3.
REINSTALL THE (2) 10-32 SHOULDER BOLTS WITH SPRINGS.
PATENT PENDING
O
(4) 10-32 X 1-1/2"
PHILLIPS PAN HD. M.S.
TYPICAL FINISHED
DOOR PREPARATION
www.abhmfg.com
R
E-mail: abhinfo@abhmfg.com
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
PULL SIDE OR PUSH SIDE ASSEMBLY
c 2014 ABH Mfg., Inc.
printed in USA
LATCH BOLT UNIT
LOCATING PIN GUIDE
EXIT ONLY PLATE
10-32 SHOULDER BOLTS
WITH SPRINGS
CAM HOLDER
LOCATING PIN
6830 REVERSE EXIT ONLY-1-03.DWG
6830 REVERSE
EXIT ONLY
REVISED 09-16-14
U
LISTED
L