LD System IBC Tote Package
Pump Installation
The pump can be either Top Mounted or Drain Mounted
on the Tote. Instructions for both installation methods
are provided on the following pages. Drain Mounting
instructions begin on page 12.
Top Mounting
1. Thread the pump bung adapter (1a) into hole in top
bracket (9). Hand tighten securely.
F
. 10
IG
2. For NPT and BSPT models only, apply thread
sealant to threads of suction tube/hose (3) then
install the end of the suction tube/hose into the
pump (1) inlet housing (F
BSPP models are designed to seal with the pump
inlet filter and do not require thread sealant. For
these models just install the suction tube/hose (3)
into the pump (1) inlet housing.
3. Insert the pump suction tube (3) through the bung
adapter (1a) and into tank (F
12
1a
hole
9
. 10).
IG
. 11). Secure the
IG
pump in place by tightening the gasket screws (1b)
(F
. 11).
IG
F
. 11
IG
4. Ground pump. See Grounding Instructions, page 4.
Drain Mounting
For this installation, install the hose reel on IBC Tote
before installing pump. Hose reel installation instructions
begin on page 13.
1. Assemble the two pump bracket pieces 4 and 5, as
shown in F
. 12 using the 4 nuts (4a) (provided).
IG
4
4a
F
. 12
IG
2. Install the pump bracket assembly to the side of the
IBC Tote. Secure the pump bracket in place by tight-
ening the knobs (5a) securely.
3
1a
1b
5
5a
3A1335K