Examining Connection Port; Removing The Battery Cover - VeriFone e285 Installation Manual

D S
EVICE ETUP

Examining Connection Port

Examining
Connection Port
Removing the
Battery Cover
To remove the battery
cover
NOTE
12
285 I
E NSTALLATION
•
A smart card reader built into the bottom of the device to process smart card
transactions. For directions on how to use a smart card, see
Card Reader.
•
A magnetic card reader, built into the top part of the device for performing
debit or credit card transactions. Swipe the card using the proper direction,
with the magnetic stripe facing up, towards the keypad. For directions on how
to use a magnetic card, see
•
A Power LED located on the left side that acts as charging indicators.
•
A CTLS functionality for contactless payments. For directions on how to
conduct contactless transactions, see
•
A SIM compartment, built into the bottom of the device inside the back
compartment.
The e285 device has one primary USB-C port used for power and download.
ACTUAL ILLUSTRATION TO FOLLOW
Figure 3 The e285 Primary USB-C Port
Remove the battery cover to access the battery as well as the SIM slot.
1
Turn off the device.
2
Place the device upside down on a soft, clean surface to protect the screen
from scratches.
3
Loosen the retaining screw. The retaining screw is captive, which means that it
cannot be fully removed from the slot.
ACTUAL ILLUSTRATION TO FOLLOW
Figure 4 Loosening the Screw to Remove Battery Cover
4
Using your fingernail, turn any of the recessed slots located on both sides of
the e285 device, to pry the back cover open.
You can also use a coin, flat tip screwdriver, the edge of a card, or any similar
tool.
G
UIDE
Using the Magnetic Card
Using the CTLS
IMAGE PLACEHOLDER
IMAGE PLACEHOLDER
Using the Smart
Reader.
Reader.